better sq with 300 watts rms? IDQ 10 or SSA Dcon 10?

[stanky1219]

nice. thats very efficient. isnt that a 700 watt jl?

 

[azimuth 5,000+ posts]

the dayton titanic 10 from parts express would have nice sq with the ppi amp.

 

[azimuth 5,000+ posts]

nice. thats very efficient. isnt that a 700 watt jl?

yeah. 700 at 2 ohms. it seems to be right at about 700, no more no less. this diamond audio d6 handles more power than it actually can put out. nice amp though.

 

[stanky1219]

i gotta check it out. im going there now.

 

[stanky1219]

i might look into that one. its really a beautiful yet simple looking design which is right up my alley. i dont like the flashy stuff. i want performance. //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[stanky1219]

more xmax and bigger coil than the dcon too.

 

[stanky1219]

im gonna run it in winisd and check out some box size options.

 

[its_bacon12 10+ year member]

I'd say it's far more dependent on the box than the subwoofer in this particular situation. Build an efficient box and either one could sound great off 300w.

 

[its_bacon12 10+ year member]

Have to keep in mind that winisd plots based on a point source with infinite space around it, not reflecting performance in car. I also prefer to model in Unibox

 

[stanky1219]

at 1.3 cubes tuned to 28hz winisd is showing a dead flat curve from 30hz up. nice driver.

 

[stanky1219]

yeah but with the eq and epicenter i should be able to get around the peaks and valleys of cabin gain. box is essential but the processors will be a big help in getting dead flat response.

 

[azimuth 5,000+ posts]

im gonna run it in winisd and check out some box size options.

it does well in either. around 1.2 ported or . 6 sealed iirc. your little toyota will have alot of cabin gain down low. id go about 1 cube ported in the lower 30's personally.

 

[stanky1219]

probably gonna go ported cuz one 10" @300 watts versus components @200 watts right in my face. i think i will need as much output from the sub as possible to keep up with the comps.

 

[its_bacon12 10+ year member]

at 1.3 cubes tuned to 28hz winisd is showing a dead flat curve from 30hz up. nice driver.

You need to remember that you're going to have a bloated bottom end with cabin gain up to +10 dB down low. If you have the space for it, I'd do an EBS enclosure

 

[stanky1219]

tune higher then?