audiopulse axis wiring question

[bonesninja 5,000+ posts]

the only coil configurations the axis comes in is dual 2 ohm or quad 4 ohm. i got the dual 2.

do like i said and measure each coil if you want to know for sure

 

[808skindiver 10+ year member]

ok

 

[dcole18 5,000+ posts]

whats so funny?//content.invisioncic.com/y282845/emoticons/confused.gif.e820e0216602db4765798ac39d28caa9.gif

you just have to remember previous threads by him...

im just laughing on the inside

 

[tc3k101 5,000+ posts]

you just have to remember previous threads by him...
im just laughing on the inside

oh thought u were laughing at me cause i thought i made some sence.

can u link me via pm.

 

[rc10mike 10+ year member]

Sound like you have it wired 4ohm final

 

[bonesninja 5,000+ posts]

Sound like you have it wired 4ohm final

not if it reads 1.6 dcr wired

 

[tc3k101 5,000+ posts]

yeah his amp is reading 2ohm load not 4ohm

 

[808skindiver 10+ year member]

my friend helped me wire my sub. he has a tc3000 and he wired mine the same as his. thilo told him to wire it like that. the way the sub is wired is a little confusing. there are wires going everywhere. its a little weird because when i hook my sub to my friends mtx te1501 amp it almost sounds louder than my aq2200d. i would think more power would push that sub harder. //content.invisioncic.com/y282845/emoticons/confused.gif.e820e0216602db4765798ac39d28caa9.gif so if i wire the sub the same as the wiring diagram on the rockford website what exact load will it have?

 

[808skindiver 10+ year member]

do like i said and measure each coil if you want to know for sure

ok i measured each coil and they both read 2.8 ohms. i checked the wiring and it was the same as it said on the wiring diagram. the overall wiring still reads 1.6 ohm. what should i do? thanks

 

[808skindiver 10+ year member]

anyone??

 

[dcole18 5,000+ posts]

get an amp that does power at 2 ohms... thats about it

 

[Kyle_Keating 10+ year member]

i have an axis 15 with dual 2 ohm. right now i have it wired up at around 1.6 ohm (multimeter). that sub os hooked to a aq2200d. for some reason it doesn't seem like there is 2200 watts being used. did i wire it wrong? anyone have any suggestions or wiring diagrams? thanks

edit

(never mind, i thought this was a quad coil)

 

[Kyle_Keating 10+ year member]

correct it is dual 2. how would i wire it to 1 ohm?

edit

you're not gonna get 1 ohm.

1.6 is the lowest

 

[rc10mike 10+ year member]

Quad?

 

[Kyle_Keating 10+ year member]

oh, was this a dual?

my bad! 1.6 is as low as it will go