Apsm 1300 stopped working???

Mr.meyhem
10+ year member

CarAudio.com Elite
Ive had it for less than a year. I hooked my sub up to my speaker amp to see how I would like the comparison of the two amps and then when i hooked the sub back up to the apsm it was in protection mode and the power light was flickering. i didn't change any setting on the amp. so why did it do this??? hooked it up to a dmm and it read 0 from the 12 v to the ground on the amp...

I'm very confused on what to do. could this be a factory flaw and would be cover by warranty or am i SOL?

 
Have you checked your fuses?
yeah fuse is good. i have it split off a distro to my speaker amp and that works fine. even tried unhooking everything and redoing it all and it still didn't work. i hooked it up directly to the battery when i used the dmm and it read 0. so its the amp //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif

 
was the amp on then you disconnected the sub wires...or did you unplug the RCA patch cables with the amp on?
car was off when i took the sub wires out and put them back in. but when i took them out my fuse was still in. it was out when i put the sub wires back in tho.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Mr.meyhem

10+ year member
CarAudio.com Elite
Thread starter
Mr.meyhem
Joined
Location
Cold as F***, MN
Start date
Participants
Who Replied
Replies
26
Views
1,776
Last reply date
Last reply from
BIGJEFF64
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top