Amp won't read 1ohm

[hellastock_rsx]

So I wired up two DVC 4ohm Boss Phantom 15s to a Planet Audio AC4000.1D amp (1ohm stable) for a buddy. I wired them as the attached photo shows so that the amp is suppose to read 1ohm but for some reason when I check the independence at the amp terminals it reads 4ohm. He's happy with it but its bothering me why its not reading 1ohm like its suppose to. Could it be a problem with the amp?

Click to read more...

 

[jigsizzle 10+ year member]

Bad meter?

Sent from my SamsungLife using Tapatalk

 

[Ridinhi 5,000+ posts]

Hope you are not using that $5 Harbor Freight meter. It does ok when reading battery voltage but when it some to ohms, the numbers jump all over the place. In my experience that is

 

[THATpurpleKUSH 5,000+ posts]

Sounds like it wasnt wired properly. Disconnect the leads from the amp and measure each side.

 

[The_Grimy_One 10+ year member]

Maybe box rise has something to do with it?

 

[BOOMINGRANDPA 5,000+ posts]

So I wired up two DVC 4ohm Boss Phantom 15s to a Planet Audio AC4000.1D amp (1ohm stable) for a buddy. I wired them as the attached photo shows so that the amp is suppose to read 1ohm but for some reason when I check the independence at the amp terminals it reads 4ohm. He's happy with it but its bothering me why its not reading 1ohm like its suppose to. Could it be a problem with the amp?

yeah could be meter i had one read 19v on my battery 1 day lol.. i have another cig lighter volt meter shows 13.7v but good meter test at amp shows 14.1.. 1st change battery in meter, then test and like he said test each sub..

 

[shredder2]

If you're getting 4 ohm at the amp with dual 4's... you're most likely series/paralled... double check your wiring

 

[Boomin_tahoe 5,000+ posts]

I am currently running dvc 4 ohm subs as well and all pos and all neg must be wired to get a 1 ohm load.

JL Audio » header » Support » Tutorials » Tutorial: Wiring Dual Voice Coil (DVC) Subwoofer Drivers

Better description and bigger since that pic you provided is kinda small to read.

I would check wiring again, but sounds like the amp isn't going into protect or being faulty. Or as already stated, get a better DMM, check batteries in it if it's malfunctioning.

 

[hellastock_rsx]

Sorry for not responding for so long but I forgot I posted this. I'm not sure how nice of a meter it is, I've used it on my subs before and it read the correct independence but I said somthing to him about taking a look at it and he said he's not worried about it so I guess I'll never know http:////uploads/emoticons/*******.gif.a649d21efc0d1fd4890a6428166586c1.gif here's a bigher pic of the way i wired them though