Amp wiring

Wire the - of the first sub to the + of the second. Wire the - of the third to the + of the fourth. Wire the + of the first to the + of one of the amp output terminals. Wire the - of the second to one of the amp - outputs. Wire the + of the third to the other output + and the - of the fourth to the other - terminal. The final load will be 2 ohms. That amp makes the same power at 2 ohms as at 1 and it will run cooler to boot.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I agree with every one above. OFC is much better. Copper is a much better conductor than aluminum.
6
990
In a case like In a case like yours I would rather recommend tactile transducers. They are like woofers without the cone section that are...
7
1K
I have a jeep wrangler 2010 4 door.. So 2 of my speakers are in the dash upfront. And the other 2 are in the bar in the middle of the car
6
1K
For clarity, why not example 2 ? Example 2 is 2 ohm...my speakers are 4 ohm and amp uses less RMS wattage with the bridged 4 ohm full range...
3
2K

About this thread

Cameron

10+ year member
Member
Thread starter
Cameron
Joined
Location
Escondido, CA
Start date
Participants
Who Replied
Replies
4
Views
486
Last reply date
Last reply from
Cameron
1720923419724.png

Jimi77

    Jul 13, 2024
  • 0
  • 0
1720923400238.png

Jimi77

    Jul 13, 2024
  • 0
  • 0

New threads

Top