amp settings

[Bobby322 10+ year member]

My friend borrowed my amp and I got it back and the settings were all over the place. I was listening to some music and it sounds like I'm not hitting the lows good at all. What setting controls this? Also, I turned the bass eq like pretty far up and its ****ing loud. But as I turn the volume up my subs start sounding funky. Basically, what should all my settings be at? System setup is in my sig

Click to read more...

 

[groove269 10+ year member]

i think you should put your settings all down to zero then work your way from there to your liking. Im sure someone will chime in on this.

 

[Bobby322 10+ year member]

anyone please?

 

[DukeNut 10+ year member]

start with these settings and then tweak to your liking

lp = 80hz

ssf = 25 hz

bass eq = 0db

phase = 0

level/gain = to what your hu's rca voltage is (4volts idk?)

 

[Jakeeck 10+ year member]

start with these settings and then tweak to your likinglp = 80hz

ssf = 25 hz

bass eq = 0db

phase = 0

level/gain = to what your hu's rca voltage is (4volts idk?)

why would u do that.. my rca voltage is 5v but my gain is at about 2.5

 

[macq32 10+ year member]

if its not playing the low notes, the subsonic filter is up too high, that should be set to 15hz.

Gain should never be over 3/4, i dont even go past half. Low pass filter... 50-80hz usually, depending on how low you like your components to get.

 

[macq32 10+ year member]

oh and dont **** with bass boost and that shit, the gain is all you need