Amp settings for my Diamonds

[korndawg 10+ year member]

Hope this in the right forum, but i have a question. I'm not 100% sure if i got my settings correct for my Diamond S600a's that is powered by a PG ti600.2. Here's what the settings are for the PG:

FREQ- 40, 110, 160, 220, 300, 450, 800

Bass 0-18

Sensitivity 6, -2

Config switch - Speaker outputs recieve high pass

Speaker outputs recieve low pass

Speaker outputs recieve full range.

what would the corect settings be for my components? Thanks

Click to read more...

 

[DejaWiz 5,000+ posts]

Consult the link in my sig and if you still have questions afterwards, post 'em.

//content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

 

[luvinthebass 5,000+ posts]

that's a sweet writeup Deja

 

[DejaWiz 5,000+ posts]

Thank you //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[Beat_Dominator 5,000+ posts]

Hope this in the right forum, but i have a question. I'm not 100% sure if i got my settings correct for my Diamond S600a's that is powered by a PG ti600.2. Here's what the settings are for the PG:
FREQ- 40, 110, 160, 220, 300, 450, 800

Bass 0-18

Sensitivity 6, -2

Config switch - Speaker outputs recieve high pass

Speaker outputs recieve low pass

Speaker outputs recieve full range.

what would the corect settings be for my components? Thanks

I'd push "Speaker outputs recieve high pass" and set the Freq to 110 as a start.

 

[korndawg 10+ year member]

I'll start with that. I turned the defeat 'on' in my HU so it'll be using the amp settings now. I had it off before. It sure made a difference in sound. Tough to say which l like better tho?