Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Speakers
Amp settings for my Diamonds
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="korndawg" data-source="post: 2880406" data-attributes="member: 553526"><p>Hope this in the right forum, but i have a question. I'm not 100% sure if i got my settings correct for my Diamond S600a's that is powered by a PG ti600.2. Here's what the settings are for the PG:</p><p></p><p>FREQ- 40, 110, 160, 220, 300, 450, 800</p><p></p><p>Bass 0-18</p><p></p><p>Sensitivity 6, -2</p><p></p><p>Config switch - Speaker outputs recieve high pass</p><p></p><p>Speaker outputs recieve low pass</p><p></p><p>Speaker outputs recieve full range.</p><p></p><p>what would the corect settings be for my components? Thanks</p></blockquote><p></p>
[QUOTE="korndawg, post: 2880406, member: 553526"] Hope this in the right forum, but i have a question. I'm not 100% sure if i got my settings correct for my Diamond S600a's that is powered by a PG ti600.2. Here's what the settings are for the PG: FREQ- 40, 110, 160, 220, 300, 450, 800 Bass 0-18 Sensitivity 6, -2 Config switch - Speaker outputs recieve high pass Speaker outputs recieve low pass Speaker outputs recieve full range. what would the corect settings be for my components? Thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Speakers
Amp settings for my Diamonds
Top
Menu
What's new
Forum list
