Amp problem

  • 2
    Participant count
  • Participant list

thetruth

Junior Member
5
0
ma
I bought a pioneer 800 wt amp several months ago along with 2 10 in rockford fosgate p1's, They worked awsome for at leat 6 months. Recently I installed 4 rockford fosgate interior speakers and a 1.6 farad capacitor. That worked fine for about 2 weeks until I was listening to music and the subs stopped working. I checked the cap and it read "lo" when usually it says 12.2 to 10.4. When the car is running with the cd player off the cap reads 12.2 but when the cd player is on it reads lo. Any suggestions would help me so much.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Using a Y RCA to split signal from amp to amp to give both amps the signal they need from the HU and subs in different /separate enclosures tuned...
3
816
Fully test it without the ACR-1. TBH it sounds like an amplifier issue. Try connecting your phone direct to the amp via a 3.5mm to RCA cable. If...
2
741
If a sub's voicecoil fails, it will usually drop impedance causing too much current to go back to the amplifier. The amplifier then protects...
15
2K
Have you checked the fuse block. With time, tight connections can loosen and cause failure. Refresh those contact points and test again. Remember...
1
1K
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
158

About this thread

thetruth

Junior Member
Thread starter
thetruth
Joined
Location
ma
Start date
Participants
Who Replied
Replies
2
Views
447
Last reply date
Last reply from
thetruth
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top