I`ve got two amps. One is an Alpine MRP-M1000 and one is an Alpine MRD-M1005. When I hook up the 1000 I get sound from my subs, when I hook up the 1005 I get no sound. The subs are wired for 2 ohms, which both amps can handle. What is wrong, do you think, with the MRD-1005
-
2Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
Using Sky High copper OFC wiring and Stinger 8000 series rcas. The US Acoustics usx4085 is rated at 85X4 @ 12.9 volts and proably close to 100w X...
- Started by Speedyed
- Amplifiers
Subs play to the beat with gain low but if I turn it up my subs play loud unwanted never ending bass that is constant and wont stop until I turn...
- Started by Adam Spiekerman
- Subwoofers
What amp/make and model and what sub/make and model. What HU being used?
- Started by Adam Spiekerman
- Subwoofers
This is what you need-
- Started by cdreece
- Wiring, Electrical & Installation
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
- Started by chris123
- General Car Audio
About this thread
- Start date
- Participants
- Who Replied
- Replies
- 1
- Views
- 1,138
- Last reply date
- Last reply from
- RangerDangerV2
New threads
-
Vintage Lanzar 12 inchHi Has anyone got the data sheet for an old Lanzar sub? I...
- Started by Mmatt
- Replies: 0
-
-
Has anyone used DataSat Amplifiers?I have a DataSat home theater system in my media room and I...- Started by Steve IZZI
- Replies: 2
-
I need Help picking the right amplifierAny recommendations for a 5 channel amp that has a 4 ohm f/r...- Started by Zach H
- Replies: 12
-
Advice: will I have enough high frequency quality / volume?I am planning out a system for my ‘04 Ram 1500 with the...- Started by Adam LaFountain
- Replies: 8