Amp Install

[PEPPER061781]

situation: i bought a small amp to adapt my head unit to my car and to give alittle juice to the speakers...it is a four channel amp...my speakers need a 4 omh charge...so the amp puts out 4 ohms...but the reccomended hook up is parellel..

Whats the solution? any help would be great.

Click to read more...

 

[mattj 5,000+ posts]

2 SVC 4 ohm wired in parallel is 2 ohm

2 SVC 4 ohm wired in series is 8 ohm.

bridge the 4 channels to 2 and run 1 speaker per channel.

 

[ParkRat 10+ year member]

If your speakers have 4ohm svc then run one channel to each speaker. Assuming you only have 4 speakers. So your Front channels on your amp run your front speakers and the rear channels on your amp run your rear speakers. Pretty straight forward. Your amp will see a 4ohm load. If you only have two speakers see above post. //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[PEPPER061781]

Thanks Folks. I Think I Just Confused Myself Is All.

Much Appreciated.