Hey! I just bought my brother a new sub for his car. I got him a Polk DB1240DVC. It's rated at 360 watts RMS. I'm looking at a Rockford Fosgate Prime R500-1 amp to power it with, but I'm not sure if 500 watts would be too much power. We are going to run it in parallel at 2 ohms. Would this amp be OK on his sub? Does anybody have any other suggestions? Thanks in advance!
-
2Participant count
-
Participant list
kr15 5,000+ posts
Polluting Residentials
Just because an amp is 500w, doesnt mean that you have to use the 500w...just scale back the gain slightly. That amp will do fine with that sub. Polk makes some great sq products, but that sub isnt particularly overbuilt. Be careful with the gain
- Thread Starter
- #3
Thanks for the advice! That makes sense. I have another question though. If we put it in a ported box, what would be the best frequency to tune it to for that sub?
Activity
No one is currently typing a reply...
Similar threads
- Locked
COMPLETED
WTB - Small Mono Amp WxDxH
NVX MVPA1
Best tiny amp
Installed a bunch, but have one pushing a sealed 12 @ 2ohm in my daily beater
Can bump it all day long and barely gets...
- Started by AnthonyO
- Car Audio Wanted
This tested well on youtube - not familiar with the brand but it is a pretty standard china build house amplifier...
- Started by saints747
- General Car Audio
Mine were as short as possible and still I had issues routing them cleanly
- Started by kanihoncho
- Wiring, Electrical & Installation
I agree with every one above. OFC is much better. Copper is a much better conductor than aluminum.
- Started by kanihoncho
- Wiring, Electrical & Installation
Pretty much. It's just a nice kit.
A solo rite Scarlett 2i2, XLR mic and a loop back cable are my next purchases so I can get accurate phase...
- Started by JoeMama541
- Amplifiers
About this thread
New threads
-
-
-
-
Need advise for batteries & 2 amps- Started by Ellessucs
- Replies: 4
-
