Looking for advice to power my DLS UP36. Not looking for used, sorry, been burnt in the past. 3 way cpmponents rated for 150rms and it says 180max(thought max was typicaly 2 x rms?). For now I am staying passive due to time and money, but could go active in the future. My HU is Alpine 7998. I am going to upgrade the HU soon also due to set of preouts that went bad. Any advice would be appreciated. Here is what i've been looking at.
4 channel
Audison SRX4 170 X 2 4 ohm bridged
Diamond D5 150 X 2 4 ohm bridged
Helix DarkBlue 4 180 X 2 4 ohm bridged
Zapco I-450 180 X 2 4 ohm bridged
2 Channel
Zapco I2100 100 X 2 4 ohm
PG X200.2 200 X 2 4-1 ohm
JBL PX600.2 180 X 2 4 ohm
DLS RA20 130 X 2 4 ohm
Diamond D6 125 X 2 4 ohm
Audison SRX 2s 180 X 2 4 ohm
Also, anyone messed with the new line of SoundStream? I know they went down hill for a bit...wondered if they are climbing back up. Thanks in advance.
4 channel
Audison SRX4 170 X 2 4 ohm bridged
Diamond D5 150 X 2 4 ohm bridged
Helix DarkBlue 4 180 X 2 4 ohm bridged
Zapco I-450 180 X 2 4 ohm bridged
2 Channel
Zapco I2100 100 X 2 4 ohm
PG X200.2 200 X 2 4-1 ohm
JBL PX600.2 180 X 2 4 ohm
DLS RA20 130 X 2 4 ohm
Diamond D6 125 X 2 4 ohm
Audison SRX 2s 180 X 2 4 ohm
Also, anyone messed with the new line of SoundStream? I know they went down hill for a bit...wondered if they are climbing back up. Thanks in advance.