Amp advice - Component and Sub

Forgive me again. God I feel really stupid. But isn't the ID8 D2 dual 2 ohm?
Btw, you guys are the best. Thanks for helping a guy out.
Don't feel stupid mann, we all make mistakes and learn, for the ID8 D2, the D2 means dual 2 ohm, which can be wired in series to acheive a final 4 ohm load or wired in parallel to acheive a final load of 1 ohm.

 
Thanks guys. I think I've narrowed it down to the PPI/PA and the vfl 150.4. :) I really super appreciate everyone's help.

I'll certainly let everyone know how it goes!

 
1) The XD500 does not push out enough power for the front components.
Do not be obsessed about having to run >100watts of power. My suspicion is that most speakers do not really handle the rated power specially when crazy numbers are given. The power handling spec is thermal limit, but most speakers will easily run into excursion limit at low frequencies with well over 100watt RMS. Another issue is that THD can go through the roof if you actually drive the speakers hard enough to make use of those 100watts of power (speaker THD, not amp THD). At the same time having too much power can't really hard even when listening at normal volume level. You get more heard room for dynamics and lower amplifier THD.

2) At 2 ohms, the XD500 pushes out 300RMS, but the ID8 D4 recommends 150RMS.

So I'm looking for advice in terms of alternative amp choices and whether I should get the 4 ohm or 2 ohm sub.

Thank you all in advance!
No problem IMHO. If you're worried too much, get hold of a DMM and set amplifier gain by DMM.

Regarding amplifier, if you're going to drive subwoofers and speakers with one amplifier, get a relatively high power 4-channel amp, as the more power is normally better for the subwoofers. I'd mention the PPI Phantom P900.4 too. This thing normally costs $200 online. The value is incredible. You get respectable 450watts on bridged channels, small case, and the thing never runs hot. Another interesting amplifier is Alpine MRX-F65. While a bit more expensive, I suspect its more refined when feeding full range speaker channels. JL Audio is a respectable amp company. If you have interest in HD or XD amp go for it.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

It also lowers the amps efficiency and raises the current draw.
5
752
The amp should still turn on regardless of your settings. Those settings will probably cause almost no power to come from the amp, but thats a...
1
1K
I would pull the amp and bench test it with power and ground wires. If it still doesn't power up, its probably shot. My next step would be to...
1
1K
Thank you for your reply. What if I wire in series for 8 ohm load ? Sorry for my newbie questions, but wouldn't it have better sound quality...
3
1K

About this thread

Mystral Hawk

10+ year member
Junior Member
Thread starter
Mystral Hawk
Joined
Location
Washington DC
Start date
Participants
Who Replied
Replies
17
Views
1,685
Last reply date
Last reply from
zako
IMG_0005 (5) - Copy - Copy.JPG

Dan Medina

    Jun 17, 2024
  • 0
  • 0
Screenshot 2024-05-31 182935.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0

New threads

Top