My vehicle has an Alpine CDE-9852 that was installed most likely in 2004 or '05 and it had a cable for iPod support. Unfortunately, the ol' iPod has died, and being that I listen to my music on my phone, and the Alpine I have does not support AUX, I'm thinking about just replacing the head unit that has both Bluetooth and an AUX input. Do all Alpine head units have the same wiring harness and am I able to swap the old Alpine out with a newer model and keep the speaker setup as is?
-
1Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
Only reason I would use the kick location was if the speaker magnets did not clear the door's regulator/glass.
As for the 3way location, I would...
- Started by red mad 1
- Enclosure Design & Construction
Hi
I have a 2006 Porsche 911 with the original PCM head unit/system. The prior owner had a Mobridge ABT2010 unit installed - it uses a Y cable...
- Started by johnnycakes
- Wiring, Electrical & Installation
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
- Started by RyanJ0022
- General Car Audio
One or two, they are still subwoofer outs and are mono summed signals from both left and right. Even the 2 RCA subwoofer pre-outs on the 2nd one...
- Started by kanihoncho
- Speakers
About this thread
New threads
-
can i keep this audio system with the ones listed below?Hello I also have a question I want to buy 160ah lto, i.e. 4...- Started by ANDREX
- Replies: 3
-
160ah lto with a stock 140a alternator with 14.9 loadHello I also have a question I want to buy 160ah lto, i.e. 4...
- Started by ANDREX
- Replies: 0
-
Stinger doing 15% offhttps://stingersolutions.com/collections/amplifiers I just...- Started by spokey9
- Replies: 13
-
-
Subwoofers popping when amplifier is turned off and onAll my speakers used to do this as of recent. Along with...
- Started by tonksie93
- Replies: 8