Aftermarket sub cuts out at high speeds and revs

  • 2
    Participant count
  • Participant list

Asuri3

CarAudio.com Newbie
2015 Lexus is250 f sport. Had this same setup in my 2012 Audi a6 and it was perfect. Just got it installed in my Lexus and the sub just cuts out at high revs and speeds. Does anyone know what is wrong. I have searched everywhere and have not found an answer.
 
Are the subs using a separate amplifier? If they are, have you tried turning up the gain/input on the amplifier? Is it possible that at high revs or speeds, that the electrical system is pulling power from your headunit and diminishing the signal to your amplifier and/or your subs? Just a guess.
 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

You can run the SVC subs on the GM-DX871 at 1 Ohm, just lower the gain at the amp. The third sub is too different to run on the same amp as the...
1
946
No way to tell if the wiring is bastardized without looking for yourself. Wiring adapters are cheap enough at installer.com. That said there is...
4
594
High pitch whine is usually a grounding or interference issue or from using inexpensive signals cables run parallel to power/ground lines. Or, as...
6
908
So you have your main power wire which feed the current it needs. Your original HU would have had it, and you probably connected your new HU to...
2
693

About this thread

Asuri3

CarAudio.com Newbie
Thread starter
Asuri3
Joined
Location
Chicago
Start date
Participants
Who Replied
Replies
1
Views
521
Last reply date
Last reply from
huberoy123
1000007733.jpg

Mr FaceCaser

    Apr 26, 2024
  • 0
  • 0
Pod on dash 1.jpeg

Doxquzme

    Apr 26, 2024
  • 0
  • 0

Latest topics

Top