Aftermarket HU switch to a new HU...now some kinks...

  • 1
    Participant count
  • Participant list

sirsaechao
10+ year member

Senior VIP Member
303
0
CA
I had a Alpine IVA-D900 & AudioControl EPIC Four.1 in my Tacoma...just recently swapped that out for a new Eclipse AVN726E minus the EQ since I don't have room for it. Now when I turn off the key, the sub will make a faint thump/pop. What is causing this? The installer (Eclipse/JL Audio authorized dealer) who worked on my truck for years says its a normal on/off thump/pop...I don't think so...because the Alpine never had this and they installed that too. Help?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

So you have your main power wire which feed the current it needs. Your original HU would have had it, and you probably connected your new HU to...
2
890
No way to tell if the wiring is bastardized without looking for yourself. Wiring adapters are cheap enough at installer.com. That said there is...
4
710
High pitch whine is usually a grounding or interference issue or from using inexpensive signals cables run parallel to power/ground lines. Or, as...
6
1K
Nice, well I think they will blow away anything you have running on your puter for sure. I've had good luck with the NVX components, hard to beat...
16
2K

About this thread

sirsaechao

10+ year member
Senior VIP Member
Thread starter
sirsaechao
Joined
Location
CA
Start date
Participants
Who Replied
Replies
0
Views
321
Last reply date
Last reply from
sirsaechao
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top