basically i dont run my amps hard at all but i want to add some active cooling (fans) just to prolong there life
comes with a plexiglass top
1) where would the hot spots be on this? the large inductor?
2) what size fan? i have all sizes from my PC builds
3) push or pull configuration?
4) should i wire a relay to the remote wire from headunit to power my fans?
i was thinking of a pull configuration and seal up any holes except the little vents on by the inputs so it cools almost the whole board
300.2 > forgot to take pic of 1000.1
comes with a plexiglass top
1) where would the hot spots be on this? the large inductor?
2) what size fan? i have all sizes from my PC builds
3) push or pull configuration?
4) should i wire a relay to the remote wire from headunit to power my fans?
i was thinking of a pull configuration and seal up any holes except the little vents on by the inputs so it cools almost the whole board
300.2 > forgot to take pic of 1000.1
