Active Capable Amp

[Bettr n' Revrse 5,000+ posts]

Heres the amp controls, that should work then I think... Hey OP I hope you dont mind me posting in your thread but I thought it may help you out too

 

[CHEMMINS 10+ year member]

Yup...it'll work. Just have to put your filters to off on both. Then you set your gains accordingly.

 

[Bettr n' Revrse 5,000+ posts]

Now this may help the op as well... but when you split up a comp set of lets say 60 rms per side... you should send 30 to the mid and 30 to the tweet correct?

 

[CHEMMINS 10+ year member]

Usually you put more to the mid than the tweet in an active setup. Tweeters are more sensitive, so putting the same power to both....the tweeter will be louder. Some passive x-overs have tweeter attenuation for this reason of -3 or -6 db.

 

[Bettr n' Revrse 5,000+ posts]

Awwww ok... Thanks for the help man!

 

[CHEMMINS 10+ year member]

Remember...you can always bring your gain down to attenuate the tweeters to blend nicely.

 

[ctmaudi 10+ year member]

The CCX65 kit is rated 100rms, but the tweets from it are rated 60rms. So Im assuming the mids will take 100rms.

My amp is rated for 80x4, so if I went active with it, it would be under powering the mids.

 

[gunz4me2 10+ year member]

All things equal, going from 80 watts to 100 watts RMS isn't going to be that big of a deal and will barely noticeable, if at all. In all honesty, I'd be more worried about over powering the tweeters in your case versus under powering the mids.