? about fiberglass panel

[brmcm15 10+ year member]

this has been on my mind for a while and most, if not all, of the fiberglass tutorials that i have looked at have not gone over this....

say im doing some door panels. I get all fiberglassing and what not, and there done, ready to be installed.

how do i install them??

do i drill a screw into the door through the speaker hole??

thats the only part i get lost at..

brm.

Click to read more...

 

[tylork92 10+ year member]

i kinda explained how i did it in my panels build...when i had my mold done i left it on the panels and drilled holes throughout the panel. Then put bolts long enough to reach all the way through. I was able to cut mine off so i didnt have to drill any extra holes in the metal of the door to fit. then cut like 4x4 squares of matt and glassed the blts into the molds...i used about 3 layers on each bolt.

 

[brmcm15 10+ year member]

yea i read through ur's for a little..

do you have any pics of if?

 

[tylork92 10+ year member]

i do not have pics of the actual process but here is a pic of where the bolts are already glassed circled.

 

[brmcm15 10+ year member]

alirght thanks for the help Tylork92...

i think what i might end up doing is putting some of the factory clips on the back of the panel so it will snap in there..