4 IA Lethal Injections 15s on GP3000D?

[RowJoe 10+ year member]

Well, at least you know about Vifa. I've read some CDT stuff (not exactly sure how much) is re-badged Vifa + markup.

8-ohm drivers will not hurt your amp(s): http://www.diymobileaudio.com/forum/diyma-tutorials/31-real-deal-8-ohm-drivers.html

Peerless Exlusives would be a nice midrange woofer: http://www.madisound.com/catalog/product_info.php?cPath=45_228_256&products_id=1604

 

[Papermaker85 5,000+ posts]

Well, at least you know about Vifa. I've read some CDT stuff (not exactly sure how much) is re-badged Vifa + markup.
8-ohm drivers will not hurt your amp(s): http://www.diymobileaudio.com/forum/diyma-tutorials/31-real-deal-8-ohm-drivers.html

Peerless Exlusives would be a nice midrange woofer: http://www.madisound.com/catalog/product_info.php?cPath=45_228_256&products_id=1604

i feel insulted.. 2 points.. i have a 100x4, i hate to waste the power.. i assure you that i understand impedance matching.. higher impedance=less current/higher voltage. again good(HOPEFULLY) compensate ie low ga winds..

 

[Papermaker85 5,000+ posts]

http://www.madisound.com/catalog/product_info.php?cPath=45_228_257&products_id=8530

no phase plug and i could give it about 60 rms... has to sound excellent and still be loud..

 

[RowJoe 10+ year member]

Sorry about insulting ya. =P

Might wanna wait for the new ID OEMs.

http://www.caraudio.com/forum/showpost.php?p=6092624&postcount=399

http://www.diymobileaudio.com/forum/member-product-reviews/58415-id-oem-v2-prototype.html

 

[Papermaker85 5,000+ posts]

thanks...im keep searching and keep the ids in mind..

 

[pd8731]

Back on topic plox?

 

[Papermaker85 5,000+ posts]

why you aint hearin it..lol you know what to do..

 

[87linkin 10+ year member]

why you aint hearin it..lol you know what to do..

Go make some paper!

 

[hornedfrog1985 5,000+ posts]

Holy shit. I've never seen anyone post so many times to themselves as mr. paper here.

 

[Papermaker85 5,000+ posts]

call me a retard, better beable to prove it.. BTW the answer to the question is... swich the leads to the correct placemant to measure mv then switch the DMM to millivolt DC check the spec sheet(coes with the transmitter) for current flow when NC/NO (most times .04ma..) if its not you have to calabriate it to spec.. secondly when flow/temp/pressure increses you gong to get more current flow, to check this you simply SERIES the meter(since is Direct Current or DC) with your common by determinating it from the PLC/panel/device and taking the + DMM lead to the common(coming off the drvice AKA transmitter) and the NEG meter led to the terminal/test on the device/panel/plc... as pressure increases you current should increase.. when it reaches the programed parameters to activate the shut down you should beable to see the same ma DC on hte meter AND manually in PSI/temp VIA gauge etc...

so in short you simply test the DC amperage in series between the device and PLC/Jbox to calabriate/test it..