2 or 4 channel?

[tigermax14 10+ year member]

Im going to be running pg rsd 6.5's and tweets up front and 2 4x6's in the back. So do i need to get a 2 channel amp and run the 6.5's and 4x6's off the amp and the tweets off the h/u? I searched and saw in another post about bridging a 4 channel to run all three off the amp, but have no idea how to go about doing that. Any help would be really appreciated.

Click to read more...

 

[ToxicBanana 10+ year member]

You have a crossover for the 6.5's?

 

[1loudmtherfuker 10+ year member]

If you want to be able to fade the rear speakers out and just listen too the fronts I would get a 4 channel amp , if not then the 2 channel will do . I wouldnt run the tweeters off the HU power , just use the crossover and run them from the amp ....

 

[tigermax14 10+ year member]

and im getting the comp set with the 6.5's tweets and crossovers.

 

[tigermax14 10+ year member]

anybody?

 

[UCF52 10+ year member]

Get a 4 channel for your RSd's and bridge it if you are running passive. Run your 4x6's off of the deck. Make sure your 4 channel can deliver at least 150x2 @ 4ohm. This will give the necessary amplification in case you decide to run active later on down the road.

What kind of vehicle is it... you mat not want to install the 4x6's until after you get the RSd's running. I am not a big fan of rear fill, but it is all personal preference. You may decide that 150 a side on the RSd's is enough - for me it is.

^^^ that is kind of a jumbled post

 

[tigermax14 10+ year member]

so if a get a 4 channel and bridge it for the rsd's, what do I use to power the tweets? and do i still need a 4 channel if I know im not going active?