2 channel vs. 4 channel

I'd say it depends on many things, including the voice coil configuration of your subs, which subs they specifically are, how much power you need, and last but not least, your budget.

 
go for 2channel amp(MRV t757) to power 6x9z and for subs find MRV1507 if you have 4ohm subs,

ur car will bang and no one will beat you in calrity. or the best would be 2 channel plus mono amp.

depends on ur subs but put in mind it will be awful to use 4chanel amp coz subs needs diff power simple .

use brain.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
319
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
455
Pretty much. It's just a nice kit. A solo rite Scarlett 2i2, XLR mic and a loop back cable are my next purchases so I can get accurate phase...
10
839
Slapz are sfb clones from my understanding. What I was pointing out is how much info slapz gives about their amps 😂
35
2K
Thanks for that. Good point about the chimes, I 'll have to check. My thoughts were that a true center channel could serve to raise the sound...
3
475

About this thread

sports_dude123

Junior Member
Thread starter
sports_dude123
Joined
Location
Phoenix
Start date
Participants
Who Replied
Replies
3
Views
705
Last reply date
Last reply from
abdulwq
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top