10" RE SX T-line enclosure

[jfink 10+ year member]

i'll let him disclose that info due to the fact that there seems to be questions with the design

sx has a pretty low QTS hopefully it sounds good

i dont support bashing of others work.

but he has done multiple boxes for others and has respect from others on here so i trust the design.

 

[snfsh79077 10+ year member]

i'll let him disclose that info due to the fact that there seems to be questions with the design
i dont support bashing of others work.

but he has done multiple boxes for others and has respect from others on here so i trust the design.

well as long as he has reputable work Im sure the design isnt flawed. Ive never worked with sx's but as long as your happy with the performance, thats all that matters

 

[mobeious 10+ year member]

wasnt bashing just saying hope it sounds good considering the woofer used .. box looks awsome though

 

[jfink 10+ year member]

i know, i just don't wanna anyhting started.

 

[mobeious 10+ year member]

just please be carful with that much power and a T-line

 

[Rawr-DQ 10+ year member]

i know, i just don't wanna anyhting started. as far as SQ of the box goes that isn't the real ?. its my woodworking skills. so even if the box does have a design flaw it impossible to place the blame on the designer.

A design flaw is a flaw caused by the designer/engineer. A Flaw in the craftsmanship would be your fault.

 

[jfink 10+ year member]

dam didnt edit it in time. i retracted that statement. basically saying that if the box sounds like sh!t, it'll be hard to say its a flaw in the design and not my woodworking skills.

 

[myvanpounds 10+ year member]

t-lines usually need a taper in them... for some reason everyone has been building them with a compression chamber and no taper lately

 

[jfink 10+ year member]

tapers are in the compression chamber right? if so i got one.

 

[jfink 10+ year member]

just checking but is this the taper that you speak of??

 

[Fiercetimbo17 10+ year member]

just checking but is this the taper that you speak of??

ya basically, was there inconsistent port width?

That could be a problem, it was very difficult to tell by the pic with the tape measure

 

[jfink 10+ year member]

holding the camara with one hand and the tape measure with the other. its about 1/16 or less of a differance.

 

[myvanpounds 10+ year member]

proper t-lines should have a taper from the driver to port usually 1.25-2 times driver sd at the driver end of the port tapered down to the driver sd at the port exit like so:

 

[jfink 10+ year member]

ohhh ok i got ya.

 

[myvanpounds 10+ year member]

i've done straight TL's myself and they usually turn out fine once you stuff them. you just need to play with the stuffing till it sounds smooth