protect

  1. T

    JL HD600/4 going into protect mode on 2 channels?

    As title. Once i get to about 4/5 max volume my JL HD600/4 amp goes into protection mode on 2 channels, powering my mids. The other 2 channels powering my woofers is fine. I have set the gains so there is no clipping at all even at max volume and it has only just started happening recently. My...
  2. Psychojic

    4 ohm sub measuring 2-2.5 ohm. Amp going into protect.

    Last week my sub fell over on its face when I took a corner too fast. Afterwards my amp would go into protect when I turn up the volume. I checked my sub for any damage and couldn't find any visually. I measured the ohms and it reads 2-2.5 ohms at the sub terminals. I also measured the speaker...
  3. M

    Amp going to protect even at low volume

    So I got a new car and put my old setup in (skar lp1000 monoblock, Jensen w12 4 ohm single coil, 4 gauge), whenever I turn up the volume slightly my amp goes to protect. Multimeter says battery isn't dropping voltage but when I check at the amp I can drop from 12 to 9.5 on a small bump, ground...
  4. T

    Amplifier Protect Light

    Hey everyone, I have a JL TMA T2 1000.1 amplifier and the other day it quit powering my sub. I got around to looking at it today and noticed the "protect" light is on. I re-attached the ground, and battery cables, still on. I then checked the fuses, all we're alright, and even unplugged the...
  5. S

    Twilight Of The Gods

    Krom, I might have done something stupid. Yesterday, I bought a new RCA cable because it looked like a better shielded model than the RCA cable I had already. After installation, I started driving to work and put the stereo on. After a few moments I realized there was no sound coming through...
  6. S

    Twilight Of The Gods

    Krom, I might have done something stupid. Yesterday, I bought a new RCA cable because it looked like a better shielded model than the RCA cable I had already. After installation, I started driving to work and put the stereo on. After a few moments I realized there was no sound coming through...
  7. S

    Twilight Of The Gods

    Krom, I might have done something stupid. Yesterday, I bought a new RCA cable because it looked like a better shielded model than the RCA cable I had already. After installation, I started driving to work and put the stereo on. After a few moments I realized there was no sound coming through...
  8. R

    Amplifier goes into protect with 12 dvc subs.

    Okay first off everything is brand new, right out of the box and into my blazer. I have an infinity 1300a amplifier and two 12 pioneer Tsw309d4 subs in a ported box. The subs are Dual Voice Coil 4 ohm and the amplifier is a two channel. I have tried just about every way to wire them.. 2 ohm, 4...
  9. U

    Big time novice questions on setup

    I've tried to find the answers on here but I really don't know enough about these things to find an answer. I have a Rockford Fosgate P2002 (probably? It's definitely a P####) amp and a Infinity perfect 12 setup that I bought from a friend a pretty long time ago. For a while, the output from...
  10. C

    Power Protection, why?

    hello all! I have a 1000 Watt Kenwood Mono channel amp (KAC-8104D) my step brother let me borrow is two sub box and one kicker comp and I put my sony Xplod in the other side. I had no problems at all, they were just too dang loud. He asked for them back so I decided to install my single Sony...
Top