Recent content by Undisputed King

Just some more clarification, any 4 or two channel amplifier will buy will be atleast 4 ohm stable. So u dont have to worry about the stability of any amp at 4 ohms, just make sure you look at the 4 ohm continuous power or RMS per channel. Like mlstrass said x2 on the power range of 85-125w RMS...

Well I took a chance and I picked up the Soundstresm Rubicon RBC.6 component set. I picked these up from auto club for 68 bucks shipped. I searched and searched and found nothing on these. So I decided I would put some information on here about them. Well first off these look to be well built...

Definately amp them before you can decide to move on to something else. I hear those type r components can get pretty loud.

Well there's no aero port kit long enough for my application, I have a 20.5 inch x 3" so aero port isn't really an option unless I made my own but I don't have a heat gun. But I was mainly worried about the internal clearance and my brace would induce noise.

Will do, if they sound good I will be getting rid of my skar and putting 4 of these under my rear seat as well. $30 bucks a pop is pretty cheap

So I built this enclosure for an cheap Lanzar Max8 for my girls car. The specs are .75 cu ft tuned to 32Hz with 3" abs port. The port has 4" clearance from the internal wall. But I just am mainly shooting for more SQ so I am worried I am going to have some port noise either because the port is...

What brand and model are they? Unless theyre powerbass then i see it unlikeky to actually be 1.5 ohms, maybe your dmm is off.

Yes well this is my best shot at it, if everything else stays the same efficiency and such, since the amplifier is linear with respect to voltage then it should be just a ratio between (oem rms watts)/14.4=(rms watts at lower voltage)/13.8 and just solve for the rms watts at lower voltage. By...

You also have to remember you have box impedance rise, you could probably have a final 2.5 ohm load even if your subs are wired at 1.5. It just varies per enclosure. So you should be fine, if your amp goes into protect then its too much for your amp. Like stated above dont set your gains to...

Check out the Soundstream TX4.560 supposed to put out 100wRMS x 4 at 4 ohms at a redculously low price of $80.75 shipped after coupon "FACEBOOK" I already bought two of them but have not put power to them yet Soundstream TX4.560 560 Watt Tarantula Car Audio Amplifier : VMInnovations.com

If theyre CompVR's aka CVR's like he states hey have to be DVC unless they are like the 2001 models. If theyre just Comp then yes they would be SVC

Yeah thats what i figured about the fuses, but i dont think the engineers and their insurance will allow for too much over fuse rating because it would become a saftey hazard. Anyways i purchased a soundstream amp already no more worries about cheap amps for me

Alright guys thanks for all the imput. Thanks for talking me out of buying that POS. I just kept looking and I stumbled across the Soundstream TX4.560 tarantula series amplifier for $90 shipped and I jumped on it, for 4x100wRMS at 4 i figured i couldnt go wrong with soundstream. GOod thing I...

So I am doing a budget install on my GF's car for christmas, just 4 channel amp and speakers and comps. And I know BOSS is crap, but I ran across this amp, and it has 3x35A fuses, so should do around 1050wRMS @ 2 ohm with 70% efficiency at 14.4v. Now for $80 dollars shipped would you pull the...

Keep in mind that I have a 4" lift I made for my back seat.