Recent content by steagan

Hi, my previous post wasn't too informative so here goes. I want to replace the factory mach 460 cd/tape head units in my 96 mustang and use the factory amps for the stock speakers and add an amp and sub. Is there an aftermarket cd player that plays mp3s, has a high pass crossover for the...

looking for a deck with high pass xover for speaker outputs and low pass for sub preamp...any suggestions

I'm looking for a head unit with a high pass crossover for the speaker outputs, not the preamp outs and a low pass for the sub out. anyone heard about or seen one?

would the amp see the dual voice coil as two speakers?

I am planning on getting a solobaric 10" or 12" dvc sub and would like some advice from you car audio gurus out there. I trust in Rockford Fosgate to supply the wattage but am unsure which amp I need to get 200-250 RMS to the sub. I know some of their amps are stable to 2 ohms and some to 1...

I've heard that RF amps are overrated and that their quality has gone over the years. I want to push a single solobaric dvc 4ohm. Should I go with RF or a more respectible company these days? Anyone with experience adding an amp to a factory system like a mach 460?

Does anyone know how to add an amp to a mach 460 sound system in a mustang? Also, what would work good with a dual 4ohm voice coil solobaric? Are RFs overrated?

I want to add an amp and sub to the mach 460 system in my mustang. Whats the easiest way?

I'm considering an amp to run one S10L7 dual voice coil 4ohm or 8ohm solobric sub. I don't want to pay more than $200. I like fosgate. Should I go with a one channel amp or a two channel amp? whats the best way to wire to get the most out of my amp and sub? also, installation into a...