Recent content by it'lldo

I have a Stinger SPP1200 that I would like to add to my system. But where to mount it? In my 2017 Ford F150

I have a Hertz HX 300 D. The HX 300 D is a dual voice coil subwoofer. I am looking at running 500 watts to each voice coil from the sub channel of Alpine PDX-V9 of two amps. Other than matching the output gains, does anyone see a problem in doing this? At 4ohm there would be total of 1000 watts...

View Listing Hertz HX 300D Like new, been in a sound quality competition system. 250.00 per woofer plus shipping. I have changed vehicles and do not have the room for three 12's. 300 mm or 12", 1200 watts peak or 600 watts continuous, Ohm 4+4, frequency response Hz 28-700...

Looking for an 8 inch shallow mount 4 ohm that will handle 500 watts each. Want three subs under the rear seat of a Ford F150.  I have three Alpine PDX-V9 amps running a three way front stage and center channel. All front stage are Hertz Mille. The subs I used in my last install were Hertz...

I called Parts Express and they have what I need. Parts are on the way.

I have a pair of Hertz ML 1600 mid bass woofer. I will be using the Amp to cross over the bottom end. What do I need to set the top side to 400 Htz@ 12 db slope or 18 db slope.

How much internal volume do I need for the best SQ ? I Will have 500 watts on each woofer in its own inclosure.

I am looking for an RTA that uses a Notebook computer with 30 bands 1/3 octave. Or should I use a stand alone unit?

A 4g wire can run up to 10 ft with 150 amps or 20 ft with 100 amps of current. But remember to use the same size wire for the ground. Put the ground on the same frame rail as the battery ground.

I use 3M 77 spray glue. You can buy it at Walmart in small cans or from Parts Express part # 440-225. Be sure to use a roller when installing the Dynamat. It is also to leave it in the sun for an hour or two. But be sure to wear gloves because the sheet will be warm to the touch.

If you can find one since their no longer in production. The Coustic DX 28. Very good quality x - over. Just food for thought. My second choice would be Audiocontrol for a mid level unit.

What you buy depends on several factors. The amount of money you have. It for SPL or SQ. What kind of inclosure are you using. And the amount of power being used. What do you like. That's important thing. I myself when I get started building my next install. I will be using two 112w6 v3 -D4...

Which 2014 AV unit has the best Sound Quality with HTML for under 1500.00 retail?