Recent content by dthor68

I am installing a Maestro SW, steering wheel control in a 2008 Honda CRV. When I flashed the unit it gave me instructions stating that I needed to tap into 1 wire from the 28 pin blue tooth module and I can not find this module. I figured it was below the head unit but it is not. There are...

I thought it was a question anyone here could answer. Love the MM6501's, love my 6 year old REF 4.760 even more.

What I have: Soundstream REF 4.760 amp powering set of Polk MM's up front and a 10" Dayton Audio Sub (bridged). I want to use stock HU with a pair of Axxess LOC's to hook up amp. And, I have a set of Focals in the back doors. Problem I have is how to power rear door speakers? I wanted to...

I have a 2008 Honda CRV EX-L. When I first purchased the truck, last year, I replaced the HU with the cheap Pioneer FH-X820BS. I want to put the stock unit back in to get all of the bells and whistles back. 1. I have purchased (2) Axxess AX-MLOC725 and a Metra reverse wire harness that fits...

The Dayton was a big winner in the poll so I got one and I must say I am very disappointed. This sub ***** compared to the $100.00 JL. I figured it would not hit the lows that the JL hit but would be louder. No, to get the output that the JL had at 20 the Dayton gets at 30. This sub is so...

I just purchased this Sub, Dayton Audio DCS255-4 10" Classic Subwoofer 4 Ohm. This speaker was recommended by a long shot over 3 other models. It looks like the volume needed for this speaker is very small at .3 cubic feet. I have a 12" x 12" x 12" Sealed Box made of 7/8 MDF. Can I just drop...

Great Point! It took me all of 5 minutes to decide what car I wanted and it was $15,000 (and used)!

I notice most votes go to Dayton, can you tell me why the Dayton is better than the JL? The Daytons are made in Taiwan, which is much better than China but still a little confused why? The JL will hit 25 htz, the Dayton goes no lower than 31 htz. However, on sensitivity the Daytons hit 91db...

I made the box. It is 12"x 12"x 12" so under a cubic foot internal. 7/8" mdf 3/4" with bracing.

Of these 10” 4 ohm subwoofers, which one would you purchase and why. I am a little shallow and left a lot of brands out of the mix that I know nothing about and a lot that look so cheap and gaudy. I admit that the Infinity looks very blingy, but it is finished in a very tasteful way and...

Back in 2012 I got JL Audio 10W0v3-4. It was only $100.00. I did not expect it to last 4 years. It worked well and sounded great, to me. I plan on spending $100.00 on the next one, any recommendations will be appreciated. Maybe the JL is still the best bet for $100.00. Thanks for any Help...

Nothing looks better than a first gen S-10 slammed to the ground. Before I even thought about a system I would body drop it, bag it and put a fresh coat, or 6, of black or burgundy paint on it. I would re-chrome the front and rear bumpers and stock grill. I would finish it off with 19" chrome...

If you had a choice between "only" two component speakers for front stage (driven with 125 watts each), which would you get? Hertz ESK-130.5 5-1/4" Polk MM6501 6-1/2"

My bad! It was the DXi6501.

Which of these components would be the best suited for a 2008 Honda CRV. The midbass is mounted in the lower part of the door. The tweeter mounts in the dash slightly angled towards listeners. However most of the sound is reflected off of windshield. In the future these components will be...