Recent content by CrysisMaker

I see where it does.

Does it have 6ch rcas?

I got the Clarion DXZ785USB that does 6v 5.6v rms time alignment etc. But I jus don't want to use it for some reason. I'll look into the JVC and a couple others. About how much does that JVC run? And since Eclipse isn't sold here anymore, what's the best way to go about getting an Eclipse unit...

Yea I was looking at the Eclipse. Wouldn't mind trying one out. What is the RCA output on that one? Looking for a nice eq. I mean a dead HU will work too. Also thought bout a JVC unit.

So I'm thinking of getting a new HU. What I have in mind is the Clarion CZ501. I'm sure there's others out there. What I'm looking for is a unit with 4v or higher RCA outputs, 6ch RCA, H&LPFs. USB and Bluetooth. This will be for SQ mainly. Willing to spend bout 200 on one. Prefered...

OP. If your into show cars and build show cars, then you should know proper way to install a system like this. You go 2 PDX1000.1s and another 4ch amp. One would think....man this is a lot of power. You have to be able to supply the demand... Otherwise...like its been said...you have pricey...

Ok, you should get a new amp kit. You can get them relatively cheap online. Go to the classifieds on here and see whats available. Youll find what you need. But the 4 ga to 8 ga I wouldnt do. Keep it consistent when it comes to the audio realm. I would never mix n match wire sizes...but thats...

4 and 8 gauge? Your using both to run power to the amp? Use 4 gauge for power. Your electrical system will be fine. If your using 8 gauge I hope its for speaker wire...

JBL are good speakers. I had some GTO series coax 6.5s in the rear deck of a 1987 Honda I had. Sounded pretty good. I don't think the JBLs would be a bad choice. The other question is, how much are you wanting to spend?

Jus save your money. By the time you get the 100 bucks something else will be avail. And hell who knows that amp might still be avail. Patience young grass hopper.

Clarion Alpine or Kenwood for me. Been using Clarion decks since 2008. They do what I need them to. The best one I've had was prolly the Alpine cda-9831. If I could find another one of those I'd buy it. Next best I had is my Clarion DXZ785USB, which is in its box. Currently using CZ500. Works...

This. Not everything for a car runs off 12v. Could be more or less. Take Bubbas advice and check. Could be out a detector if you dont... Also, you can go to the manufacturers web site and see if they give any specs for voltage. If not, Google may help.

You can use a chassis bolt as I suggested earlier. Such as a anchor bolt for a seatbelt. And please don't run your ground wire to your taillights and ground there... The cable should be around 12in in length anyway. Remember to take away any paint or sealant, you want direct metal to metal...

Google?...

This..