Recent content by bad03ranger

I picked up 8 CHEAP dual SD12 subs and wanted to do a stupid box in my 02 explorer, just a simple sealed enclosure, my question is can I leave this as a shared enclosure for all 8 subs or not? I'm not looking to set any records or win comps but just say I got 8 12s but I still want it to sound...

Looking for a decent HU on the cheaper side. It's for my 16yr old nephews first car Walmart.com: Pioneer DXT-2369UB Complete Car: Auto Electronics Looked at this pioneer HU and speakers but was unsure if its a decent HU. I know for $85 what can you expect, just want to make sure I won't...

Hifonics ZXI6.5C Hifonics Zeus ZXi 6.5C 6.5" Component Car Speakers Alpine SPS-610c Alpine SPS-610C (SPS610C)6.5" 2-Way Type-S Component Car Speakers

what about pyle and lanzar i can get those off amazon for like $40

Putting a HU in my nephews 90 Ranger reg cab gonna be running a DD508b and wondering if running coax off the HU with bass blockers will be a decent SQ or if (for the money) components would be better coax from $30-50 comps from $80-100 100W RMS per channel off the amp dont want to spend over...

For a tune of about 41Hz I'll have to run a longer port with a 3" port diameter For a tune of about 36Hz I can run the smaller/shorter port The main reason i was going with the 1 1/2" port is b/c I can run it out the top of the box unrestricted if I run the 3" I'll have to run out the...

1 1/2" port 3 1/2" long

3" port 12" long

Running a DD508 in a reg cab ranger with about. 8 cuft need some opinions or help on round ports. I've checked on some online calculators and for a 1.5" diameter port it should be 3.5" long would I be better of off running a larger and longer port for lower frequencies?

So what frequency should I run my rear fill at or should I just eliminate the rear all together? I buy DD. @ dealer cost so they're not that bad on $ but if it's pointless to run them I'll save the money and upgrade elsewhere

Oops wrong set these Rear: DD-AW6.5 Power Handling 120W RMS

I plan on upgrading the speakers in my accord with some DD stuff i have, I want to use a C3b i have and run each channel at 2ohms (L for fronts R for rears) any issues with running this set up Amp: DD-C3b Cont Power at 2 ohm 300W x 2ch Front: DD-CS 6.5 RMS Power handling 160W per CH Rear...

So how bout a ASA 600.4 Total Harmonic Distortion:

the amp is 1% tested so will 2% be audible to the ear

I have a DDC2b for my comps and coax but just want to know if there is any issues running them at a 2ohm load per channel? The amp is 2ohm stable per channel but will SQ reduce running it this way?