Thank you there were amps mounted in the middle on the shelf's, but I didn't get a picture of them before I switched amps.Nice and clean, I like that.
How? I could barely get my stinger wire through there.You can use this tip for running your wires.http://www.clubgp.com/cgi-asp/mods.asp?modid=2
I believe they are using 4 gauge wire but I ran two runs of 1/0 through the same spot.
How? I could barely get my stinger wire through there.
Just like that.should not be to hard, take out the big rubber piece from the inside, and the the hard part just get it through the rubber boot in the engine bay. it easier to go from inside to the engine bay. i taped a screw driver to the end of the wire so it would poke a hole in the rubber boot and get in to the engine bay then i just pulled it all way through.
I was, I am taking a year off of school right now and working at FedEx back home in Evansville, but I make pretty regular trips up there to see friends. Should be heading back up there after I get the new setup installed.op you going to purdue?