- Thread Starter
- #16
jsut gunna post this so if anybody i searching for this same problem. it was my tinsel lead. the positive on the woofer not working had a very small burn mark and the wire had split. i put a bead of solder where the coil comes from the cone and the tinsel lead connects, and then just ran a small piece of like 14 ga wire to the solder.
if i just soldered the wire where it came apart, as soon as the woofer gets any excursion, it would come loose, so there was th need to run a whole new wire. hope that helps somebody in the future.
if i just soldered the wire where it came apart, as soon as the woofer gets any excursion, it would come loose, so there was th need to run a whole new wire. hope that helps somebody in the future.