Last edited by a moderator:
keep_hope_alive Premium Member
Acoustics Engineer
You didn't describe what wire kit you had/have/want. One safe bet is to add up the fusing on the two amps and have an amp kit that is rated for that total amperage. Don't forget the fuse at the battery! That can be sized for the wire (usually comes with the kit).
I'd get a 4ga wire kit, and run it to a distribution block. But I wouldn't use a monoblock to run 6x9s.
keep_hope_alive Premium Member
Acoustics Engineer
Some monoblock amps have a permanent low pass filter, make sure yours do not.
Activity
No one is currently typing a reply...
Similar threads
How many watts are you going to be running? Which amp(s)?
- Started by mat3833
- Wiring, Electrical & Installation
The Kappa's have a high sensitivity rating of 93 db so the X802-5 would be fine. A good high sensitivity 8" sub in a properly sized box would fit...
- Started by kanihoncho
- Amplifiers
Yup , the dsp should have input sections, it may have one for sub?
Hu to dsp. Dsp to amps, amps to speakers. Probably help you to draw this all...
- Started by supafly1
- General Car Audio
Thanks man! Quitting drinking and battling DRESS syndrome has given me a new outlook on life.
- Started by ikpthegame
- Enclosure Design & Construction
This may be an option for you as well. Im sure Amazon has them on theyre site also to be purchased. Great amps...
- Started by Chris Gerrish
- Amplifiers
About this thread
- Start date
- Participants
- Who Replied
- Replies
- 3
- Views
- 732
- Last reply date
- Last reply from
- keep_hope_alive
Latest topics
-
-
-
OFC vs CCA for wiring amp to car and for speaker use . . .
- Started by kanihoncho
- Replies: 5
-
Suggestions on 6 channel amp/powering 3 way active front stage and driver selection.- Started by JoeMama541
- Replies: 5
-
suggestion of which Butyl Automotive Sound Deadener Mat?
- Started by slater
- Replies: 13