I've never done this before but I'm not too shabby with electrical stuff. I have a multimeter as well. My 2007 Rockford p400/4 (no onboard fuse) shot into protect when I hit a bump awhile back. All connections were tight, and I see no popped caps or burns on the board. So where do I start? Amp stays in protect with and without rcas, with and without speaker wired in.
Boomin_tahoe 5,000+ posts
Hurtin' feelings errrday.
Bad ground. Check connections.
Btw....so much info about this subject AT LEAST a few times. Search for it. Also youtube helps too.
Btw....so much info about this subject AT LEAST a few times. Search for it. Also youtube helps too.
- Thread Starter
- #3
Will do. I ground on my strut towers. I have my batt, 3k and my 4ch grounded on the same nut though. Rookie mistake? Should I give each their own spot?
BOOMINGRANDPA 5,000+ posts
WOLFRAM FTW
diff grounds are better just make sure paint is sanded off..
- Thread Starter
- #5
Yea paint is already sanded on that one. Next day off I'll ground in another location and see what happens. Are there better places to ground? I'm thinking about upgrading wiring since I'll be adding more batts in the future, and I'll be running all power wire under the car. Is there a good place under the car to ground?
I guess you can run a ground to your front battery?
akheathen Premium Member
trianoacitol contraceptiv
mostly what i see on those, is broken connections at the board/terminals, bad display (yes, that does shut it down), and blown fets, which you can see.
Activity
No one is currently typing a reply...
Similar threads
Mine were as short as possible and still I had issues routing them cleanly
- Started by kanihoncho
- Wiring, Electrical & Installation
I agree with every one above. OFC is much better. Copper is a much better conductor than aluminum.
- Started by kanihoncho
- Wiring, Electrical & Installation
Pretty much. It's just a nice kit.
A solo rite Scarlett 2i2, XLR mic and a loop back cable are my next purchases so I can get accurate phase...
- Started by JoeMama541
- Amplifiers
One or two, they are still subwoofer outs and are mono summed signals from both left and right. Even the 2 RCA subwoofer pre-outs on the 2nd one...
- Started by kanihoncho
- Speakers
Speaker ratings are generally a thermal/mechanical limitation of the drivers. Music is dynamic, not continuous. During quiet periods a song, you...
- Started by kanihoncho
- Speakers
About this thread
Latest topics
-
BOSS560RBG How to connect a sub, powered or otherwise.- Started by Carlos_510
- Replies: 3
-
-
-
-