-
2Participant count
-
Participant list
Are you talking Toolmakerz. I have the Distro blocks on my D3400 with dual runs of Zero and the Big 3 done. Pic
- Thread Starter
- #3
Yea thats him thanks...
I wonder if I can put those Kinetic sidepost deals (KHC-SPA) on just for the Factory wires, then those Toolman Blocks on the top to run all the extra Audio system Wires???
I'm not actually sold on the Kinetiks, I actually like the fact that the XS Power have the TOP and Side post built in...
What'd you do in the back as far as Batt(s), distribution
and what H.O. Alt wise??? I'm assuming running 2 runs of 0/1 your system as 2000+ watts (likely more).
Thanks again
Smullen
I wonder if I can put those Kinetic sidepost deals (KHC-SPA) on just for the Factory wires, then those Toolman Blocks on the top to run all the extra Audio system Wires???
I'm not actually sold on the Kinetiks, I actually like the fact that the XS Power have the TOP and Side post built in...
What'd you do in the back as far as Batt(s), distribution
and what H.O. Alt wise??? I'm assuming running 2 runs of 0/1 your system as 2000+ watts (likely more).
Thanks again
Smullen
Last edited by a moderator:
Activity
No one is currently typing a reply...
Similar threads
Check your rca voltages and see where the signal stops being produced
- Started by alohaustin
- Wiring, Electrical & Installation
/\ Agree /\
https://glowevoltage.com/product-category/batteries/
- Started by AnthonyO
- Wiring, Electrical & Installation
What the ****? Are you trying to put ohm's law into very complicated verbiage?
- Started by McA
- Wiring, Electrical & Installation
I like the way these look. But whatever I do it has to be top post. My battery is on the driver side and right beside the air filter housing. So...
- Started by .........
- Wiring, Electrical & Installation
About this thread
Latest topics
-
-
-
-
Jeep center console sub install issues.
- Started by vlusardi
- Replies: 1
-
