-
7Participant count
-
Participant list
blabo219 10+ year member
Senior VIP Member
A little more info would help..
Check fuses? Protect mode? Smell? Loose wires? Weird noises?
Check fuses? Protect mode? Smell? Loose wires? Weird noises?
sacsking916 5,000+ posts
stayin high an loud
Wtf is a stax 1200/4? Got pics
Phoenix Risen 10+ year member
OG.... Original Ginger
Power Acoustik STAX1200/4 4 Channel Amplifiers at Onlinecarstereo.com
its this.
my guess is that op has it running at too low of an ohm load
its this.
my guess is that op has it running at too low of an ohm load
IonRL205 10+ year member
DJ h4z4rdes
Either too low of an ohm load or he's clipping and it's eventually getting too hot and going into protect.
thegreatestpenn 5,000+ posts
lazy genius
Could be the remote wire signal voltage. My remote wire signal from my hu wasn't strong enough for one of my concept amps a few years ago so I had to put a relay on it to keep the amp from cutting off and on
Activity
No one is currently typing a reply...
Similar threads
gain set well below "Normal" and base boost is off completely
- Started by brice15s
- General Car Audio 2
Lol! I just pictured you with a top hat, monocle, and a hand on your chin!
- Started by Cbjax
- Wiring, Electrical & Installation
Thanks for all the advice. Ultimately, I was able to get them to honor the warranty contract. It took a lot of back and forth and I received...
- Started by Chris Morton
- Wiring, Electrical & Installation
Never said they were. Commentary was more to being able to purchase one or the other or 40% off and take a 90 day warranty... which I would in a...
- Started by Fabian12
- Amplifiers
Lowering the impedance will also lower the speakers motor control, or damping, in physics no free lunch exists.
It’s all give and take.
- Started by Paul Curtis
- General Car Audio
About this thread
- Start date
- Participants
- Who Replied
- Replies
- 6
- Views
- 569
- Last reply date
- Last reply from
- thegreatestpenn
