toymachine2628 0 #1 Posted February 26, 2008 I decide to get the morel dotech ovation 6.5" comp set. For about a week i was running these @ 111 rms w/ an infinity 7541a amp. i decided to brigde the amp and send 278 rms to each channel, my question is can these speakers handle this power? what do you think of my installation so far? XO is in a temp location, and waiting for EDEAD to get here. Share this post Link to post Share on other sites
edzy 2 #2 Posted February 27, 2008 I wouldnt do it. The rms is 140 on em. Sure they will take more, but double? Its risky on an expensive set of drivers. I have the PG TI Elites (made by Morel) and they rate at 300 rms. I put 300 rms into them and they did not like it. I now run them at 100wrms. (after New Tweets, and the cone seperating from the rubber sourond) Got to love warranties. And before anyone starts that, clipped them crap, it was off a PG SX4600 bridged. sorry, bit off track there. But if your not happy with the 111 watts, i would go to maybe 200 with a clean amp and good install. Good luck. Nothing to see here, Move along. Share this post Link to post Share on other sites
toymachine2628 0 #3 Posted February 27, 2008 yeah, i dont want to send them that much power, but they sound so much more accurate and cleaner. Share this post Link to post Share on other sites
"Junk in Her Trunk" VW R32 Started
The despicable whine noise. Started
Ported box help for hdc3.15 Started
