WTB 250-350x1 @ 4ohm amp

Profile CA600, factory refurb with 1yr warranty gives me 450x1 at 4ohm bridged, that's probably what I'll go with because I dont have faith it'll do its full power...

That's assuming no one has anything cheaper than around 80 bucks...?

 
CA400 profile should be all right, it's 300x1 rms at 4ohm, so unless anyone can get me an amp that is going to outdo that for under 65 bucks...

Figure it says 300x1rms, I should get near 250ish, eh?

 
Oops, sorry, not much of an idea, just a very good inexpensive amp whihch is not mine... I have no idea about any of it but it does do 2 ohms bridged and slammed the 'Bahns nicely and it pushed my Bhrama aroud allright.

 
Oops, sorry, not much of an idea, just a very good inexpensive amp whihch is not mine... I have no idea about any of it but it does do 2 ohms bridged and slammed the 'Bahns nicely and it pushed my Bhrama aroud allright.

All the Pioneer 2-channels listed with a 760w max do 380w RMS @ 4ohms when bridged. I used to have a GM-5000T the pused a couple budget 12's with no problem. Someone on these boards was selling one for like $80 shipped. Also try ebay.

PIONEER GM-5000T

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

MisterGrubbs

5,000+ posts
Kinda Old School
Thread starter
MisterGrubbs
Joined
Location
Newnan, Georgia
Start date
Participants
Who Replied
Replies
16
Views
741
Last reply date
Last reply from
LoudCrownVic
IMG_0710.png

michigan born

    May 14, 2026
  • 0
  • 0
IMG_0709.png

michigan born

    May 14, 2026
  • 0
  • 0

New threads

Top