Would this work?

[iceman1110 10+ year member]

Just say that I had a DVC speaker each coil being 4 ohms, and 2 channel amp which creates the power I need at 4 ohms(however it is only stable at 4 ohms in bridged mode. My question is, since a dvc 4 ohm can only be wired to 2 or 8 ohms, could I wire each coil to one of the channels of the amp? I thought this might work since my HU only has one sub out RCA so both channels would be getting the exact same signal correct?

Click to read more...

 

[azbass 5,000+ posts]

id not do that. and get a woofer that is a 4ohm final impeadence.

 

[j3bus2k3 5,000+ posts]

Your amp can't be bridged to be stable at 2 ohms? If not, use splitters to split the sub rca as to utilize both sets of inputs on the amp and then run each channel to their respective voice coils...

I think that would work and MIGHT be safe...

 

[iceman1110 10+ year member]

Yeah i have a splitter on it now thats kind of where I got the idea, just checking in though to make sure its ok