Wiring Setup, Different Impedances

  • Thread starter Donald_S
  • Replies 0
  • Views 445

Donald_S

Junior Member
Hello all. I have a 2018 Ram 1500. In my dash I have Kicker 46cs 3.5" coaxials. I just installed a pair of Infinity Kappa 90csx's in the front doors and flush mounted the tweeters in the sail panel. Right now I have a factory stereo, but I will soon replace that with a JVC M650BT. I will also be adding a Pioneer GM-D8704 4 channel amp. Because I often take people to concerts and on trips in this truck, I will likely either add another pair of components or coaxial in the back. I haven't really made up my mind on that. I know a lot of people say it hurts the soundstage but I do want my passengers in the back seat to have clear music as well, especially since my eventual subs will live under their butt :).

My question is what to do with the Kicker dash speakers. Since they have a different impedance (Kickers are 4 ohm, Infinitys are 2.5 ohm), will it cause problems if I kept them in? The factory wiring setup has them and the front door speakers bridged. I believe the Pioneer amp will put out 135 watts RMS at 2.5 ohms but I'm not sure how the 4 ohm speaker bridged in there would affect it. Any help is appreciated. Thank you
 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Donald_S

Junior Member
Thread starter
Donald_S
Joined
Location
Weirton, WV
Start date
Participants
Who Replied
Replies
0
Views
445
Last reply date
Last reply from
Donald_S
1778578257023.png

Glen Rodgers

    May 12, 2026
  • 0
  • 0
Screenshot_20260511_212804_Amazon Shopping.jpg

Blackout67

    May 11, 2026
  • 0
  • 0

New threads

Top