wiring geniuses! i need your help.

im taking it the subs are both dual 1 ohm? if so, this will give you a 1 ohm load.

2_2ohmDVC_2ohm1-1.gif


 
thats the one i thought i would use..but..how would i wire them together? wouldnt i need a wire going from one coil on one sub, to one coil of the other sub?

or do i split the initial wire comming off the amp into 2?

 
makes sense. i thought about that before, but how could i go about doing so? any helpful suggestions?

im using 8ga wiring for my subs, and my terminals only allow 1 8ga max per terminal, so is there any way to do it the "right way" or do i just go for it give it hell, mash twist and thread 1 piece of 8ga in both sides of the terminal and put tape around it?

 
i like to solder the wires together but thats just me //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif. but twisting the wires together will work too.

 
ok. i know im being noobish but i want to make sure its right. so i peel back half the 8ga (essentially making it 12ga) on both wires, twist it so its 8ga size and shove her back in, and trim the excess? and tape, of coarse.

 
excellent.

it pulls the job more than perfect. it just kindof happened a few systems ago that i used 8ga for my subs, as i was ready to wire everything thats all i had, and it fit perfectly. **** sure no loss of current

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

billabongcr

5,000+ posts
Yep
Thread starter
billabongcr
Joined
Location
Florida
Start date
Participants
Who Replied
Replies
11
Views
596
Last reply date
Last reply from
Team Hammer
561786595_18427607485102160_7010259965928918509_n.jpg

just call me KeV

    Oct 9, 2025
  • 0
  • 0
561583216_18427455586102160_8141545757991593433_n.jpg

just call me KeV

    Oct 9, 2025
  • 0
  • 0

New threads

Top