Wiring EQ Question

I'm thinking about putting my little eq back in, but i've come upon a problem. My HU has front/rear/sub preouts. my eq only has 1 input. How do i make this happen? My eq is DAEQ-50 (Digital Audio)

The answer depends on how many outputs your EQ has.

If its just one pair in, one pair out, the only way to use it would be to EQ just the front channels (where it would make the biggest improvement anyways).

 
this is the one i have:

DAEQ50

in-dash equalizer & pre-amp

Five-band stereo equalizer (45Hz, 100Hz, 700Hz, 2kHz and 15kHz)

Subwoofer frequencies adjustable 35Hz/250Hz

Universal half-DIN chassis for ease of installation

Active gain pre-amplifiers with adjustable input sensitivity

Volume gain with up to 8v output

Individual left and right sensitivity controls for DVD input

Low noise BI-FET op-amp design yields minimum distortion

On-Board 30V bi-polar switching power supply Subwoofer output and level controls

Gold-plated RCA input connectors

20dB headroom eliminates signal overload

Main / DVD input selector

Dimensions: 1" (H) x 6 7/8" (W) x 3 13/16" (L)

good? or no?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

jco1385

5,000+ posts
expert jcologist
Thread starter
jco1385
Joined
Location
Mobile, AL
Start date
Participants
Who Replied
Replies
11
Views
1,093
Last reply date
Last reply from
jco1385
IMG_0710.png

michigan born

    May 14, 2026
  • 0
  • 0
IMG_0709.png

michigan born

    May 14, 2026
  • 0
  • 0

New threads

Top