wiring DVC subs

[spacegear 10+ year member]

i have a 4 ch. amp. id like to hook up 2 subs DVC. do i have to parallel or series it or can i simply hook it up jst like an ordinary speaker. one side on the left and the other on the right channel?

Click to read more...

 

[dkguitarist 5,000+ posts]

depends on what the final load the amp will see and if it's optimal for your subs. what's the configuration of the subs and what's the amp?

if it's too low, then the amp will probly fuxor up or go into protect. you want the lowest safest load the amp will be able to handle that will be optimal for your subs vc config.

 

[Johnny Drama 5,000+ posts]

We will need to know what the coil impedance is on the sub.

Usually if they are dual coil they are going to be dual 2 or dual 4 ohm coils.

If you dont already have the subs and you have the amp you will need dual 2 coils so that you can wire the amp to 4 ohms a side.

You will want to bridge each side of the amp and run one sub to two of the bridged channels.

There is a sticky at the top of this section to help you wire them.