Wiring confusion:(

[Zakerid 10+ year member]

prob 1 is going to the starter solenoid... if i was local i would help but it is hard to explain over a comp

 

[damonhargroves 10+ year member]

get your meter and do a continuity check on ground. ground one of the leads on your terminal and touch the wires. if you get continuity or hear a beep that wire needs to go to ground

 

[audiobahnuser18 5,000+ posts]

zakerid please explain to me more does it get it's own seperate terminal then? what do i do with the body ground and that other wire then.

 

[audiobahnuser18 5,000+ posts]

what im asking zakerid is does each wire get it's own seperate ring terminal? or do some of them have to get tied with another.

 

[damonhargroves 10+ year member]

the body ground is going to the ground on your battery....derh

 

[audiobahnuser18 5,000+ posts]

zakerid what do i do with those other two wires. do i tie them together do i give each one its own ring terminal?

 

[audiobahnuser18 5,000+ posts]

damon what did u mean by the meter test what exatcly do i do ? set the meter to what also?

 

[Zakerid 10+ year member]

doesn't matter if they are tied together or on separate terminals. what does matter is where they need to go. i'd like to see what is going on under that hood rather than blindly giving advise.

 

[audiobahnuser18 5,000+ posts]

the pics i have zakerid are on page two.

 

[Zakerid 10+ year member]

yes... you have a ground, 2 questionable wires and a batt terminal with 4 cut wires.... something is not adding up here.

 

[Zakerid 10+ year member]

http://www.autozone.com/images/cds/gif/large/0900823d800ba9da.gif

 

[audiobahnuser18 5,000+ posts]

Thanks for that diagram zakerid man appericate it. me and my dad worked on it and i did something stupid on my part i cut the wrong wire from the positive and had 2 positive's basically but i just had alot going on at once and what not so wasn't thinkn straight. uploading pics now.

 

[audiobahnuser18 5,000+ posts]

pics up. i know all diffrent color's but my dad helped yellow to match battery and blue to match my sub's idc it was a good father and son experience //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif. 2morro he's helpn me run my wire.

 

[Zakerid 10+ year member]

i would solder those terminals.... heat them up with a mini or propane torch and solder them up. I wouldn't be surprised if you could pull those wires out as they are now.

 

[type[s5] 10+ year member]

i would solder those terminals.... heat them up with a mini or propane torch and solder them up. I wouldn't be surprised if you could pull those wires out as they are now.

x2... unless you had them vised.