Wiring 2 Channel in Mono

[ribrown]

I have a PPI PC2600 amp. 150 watts x 2 or 600 x 1 (at 4 ohms). I want to use it to drive either a JL Audio 12W6 which carries a 2 ohm load, or a 10W7 which carries a 3 ohm load. Would there be any problem using this amp for the single 10W7 at 3 ohms? What about using that amp to drive a 12W6 at 2 ohms? I know the amp shuts down if it detects low impedance.

Any advice is welcome.

Thanks

Click to read more...

 

[revrider1 5,000+ posts]

U might kill it if u run it lower than recommended load bridged...

 

[ribrown]

revrider1, So below 4 ohm in mono is hazerdous?

Thanks for the responce.

 

[SicAudio 5,000+ posts]

anything under 4 ohms bridged it shuts down you just said so in ur original post try it and see if it wont work it should just protect so no harm in trying