will these work as terminals?

[04_edge 10+ year member]

i mean, ive seen it done before, but im not sure if its a certain type of bolt or what...

Click to read more...

 

[j3bus2k3 5,000+ posts]

yea, just use washers inb/w the nut and the wood...

 

[jeepintn 10+ year member]

yea, use washers, and when i used them, i used two nuts on each side of the wiide(tightened the wire terminal between the two nuts) for a better connection

 

[Death By Bass 10+ year member]

get flat washers, spring washers, and wing nuts //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[04_edge 10+ year member]

ok, one more question, im going to wire it in parralell, its dual 1, can i just run each positive and each negative to the bolt or do i have to run positive to positive and then to the bolt? sorry this is the second set up ive ever had, and the last time i did this was a year ago, so i wanna be sure about this...

 

[jeepintn 10+ year member]

either way, although running all of them to the bolt will require more wire obviously