Width on 3 Tens

image3jh.gif
 
ok seriously tho. Will 35 be enuff? I wanna keep the front flat tho. No hexagon thing. I was thinking since I have 14 height i could mount the middle ten a little higher than the two bottom.

 
as in makin the chambers separate?
Separate chambers arn't necessary, and you're better off with one common chamber for a ported application. But you should still have some form of bracing. Use a divider just like it was a separate chamber, but cut out some of the meat so that air can freely pass through. It should end up looking like a +. Or you can just use a 3" or bigger hole saw and put a bunch of holes in the dividers.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

JoseMCeee

10+ year member
$tack
Thread starter
JoseMCeee
Joined
Location
Bay Area, CA
Start date
Participants
Who Replied
Replies
14
Views
908
Last reply date
Last reply from
JoseMCeee
IMG_20260515_202650612_HDR.jpg

sherbanater

    May 15, 2026
  • 0
  • 0
IMG_20260515_202732887_HDR.jpg

sherbanater

    May 15, 2026
  • 0
  • 0

New threads

Top