What's the best way to get rust from the sub?

[GAM3OVR 5,000+ posts]

First of all, Thx for reading. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

I got an Eclipse I bought a while back that has a bit of rust on her bottom.

Since I'm doing a box for both of these soon, I'd like to make em nice an purty

I'd like to get that NASTY RUST ish off.

There's not much, but it still bugs me.

Advice = much Appreciated

Click to read more...

 

[JimJ 5,000+ posts]

Naval jelly?

 

[tommyk90 5,000+ posts]

Rubbing compound and a polishing wheel.

Might have to take some light grit sandpaper to it then polish it back up to a nice finish.

 

[GAM3OVR 5,000+ posts]

Where the devil would I get it, and how is it applied?

-Thx for the input JimJ

 

[Parker G 10+ year member]

CLR Remover then hit it with some WD40

 

[revrider1 5,000+ posts]

Whatever u use just be carefull not to drop stuff in the vent...

 

[GAM3OVR 5,000+ posts]

Rubbing compound and a polishing wheel.
Might have to take some light grit sandpaper to it then polish it back up to a nice finish.

Rubbing Compound?

Any particular brand? Or would I just walts into home depot/lowes and say gimme rubbin compound

 

[GAM3OVR 5,000+ posts]

Whatever u use just be carefull not to drop stuff in the vent...

That's what I'm worried about //content.invisioncic.com/y282845/emoticons/crying.gif.ec0ebefe590df0251476573bc49e46d8.gif

 

[DBfan187 5,000+ posts]

If it's not aluminum muriatic acid with some water will take it right off. Just make sure you rinse it immediately.

 

[revrider1 5,000+ posts]

That's what I'm worried about //content.invisioncic.com/y282845/emoticons/crying.gif.ec0ebefe590df0251476573bc49e46d8.gif

Try some fine Steel Wool...

 

[GAM3OVR 5,000+ posts]

If it's not aluminum muriatic acid with some water will take it right off. Just make sure you rinse it immediately.

It's an eclipse Ti 15" Sw9152 3Hp Motor.

Idk, could be

 

[GAM3OVR 5,000+ posts]

Thx guys, MAD FAST Advice.

Anybody ever done it, any good tips or ways to do it?

I don't wanna **** nething up.

Ti's are hard to get nowadays

 

[SilverSquared 10+ year member]

blue magic compound will do the job. And leave a protectant over it, so 1 stage and you have rust gone, polished finish, and a semi coat of clear

 

[revrider1 5,000+ posts]

Even some 3M Microfinishing compound might work

 

[Parker G 10+ year member]

Yea I used calcium-Lime and rust remover that I picked up @ dollar general. Put some on a rag wiped the motor off then with a clean wet rag wiped it down again. Dried it off and sprayed some WD40 on a paper towel and went over it again to prevent it from getting rusty again.