What's needed for Orion 2500D ...............

BassBooster
10+ year member

Member
I jus bought a orion 2500d.....as of right now I'm only gonna use it for 4ohm load (1200watts rms) but I plan to very soon add a third sub and them at 2.67 ohms (1700+ watts rms) I hear this amp is underrated so I'm not sure but my electrical right now is jus a factory alt that is 105 amps and the big three done in 2 guag wire. Before this I had a audiopipe 1500d and had dimming pretty good with some voltage drops while I drove. What upgrades do I need to prevent this from happening again?

 
If you have a deep cycle up front, which should be your first electrical upgrade after the Big 3, then just one G31 out back should be sufficient if your alt. is functioning correctly and you run two runs of 0/1 awg to the back batt, in my experience.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

BassBooster

10+ year member
Member
Thread starter
BassBooster
Joined
Location
DeKalb,TX
Start date
Participants
Who Replied
Replies
17
Views
1,028
Last reply date
Last reply from
BassBooster
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top